Garage Door Cable Repair in Austin, TX
A frayed, loose or snapped garage door cable can leave the door crooked, stuck, or unsafe to move. In & Out Garage Doors repairs and replaces garage door cables across Austin and checks the springs and drums they work with. Call (512) 704-2552. We are open 24 hours and offer a free estimate.
Get A Free Quote
What Garage Door Cables Do, and Why They Fail
The lift cables are the steel lines at each side of the door. They run from brackets at the bottom corners up to drums on the spring shaft, and they carry the weight of the door as it moves. On doors with extension springs, a second set of safety cables runs through the springs. When a cable frays, stretches, or comes off its drum, the door lifts unevenly, hangs at an angle, or will not move at all.
Cables wear from rust near the bottom of the door, from rubbing on a misaligned drum or pulley, and from the shock when a spring breaks. Moisture at the garage floor is hard on the lowest few inches of cable, which is where rust usually starts. A cable under tension can whip when it lets go, and the bottom brackets it attaches to should never be loosened by a homeowner. If you see loose cable hanging beside the door, stop using the door and call.
Free estimate in Austin
Tell us what the door is doing and where you are in the Austin area. You get a free estimate and the price before any work starts.
Garage Door Cable Services
We replace broken lift cables with new cable matched to your door's height and weight. Both sides are replaced together so the door lifts evenly.
A cable that jumped its drum leaves slack on one side and a crooked door. We reset the cable, check the drum for damage, and correct what let it slip.
Broken strands are a warning that the cable is close to failing. Replacing a frayed cable now is a small repair compared with a door that drops.
Doors with extension springs need a safety cable through each spring. We add or replace them so a broken spring stays contained.
Worn drums, cracked pulleys and rusted bottom brackets chew through new cables. We inspect them and replace the ones that would shorten the life of the repair.
Cables and springs work as one system. We check spring tension, level the door, and run the opener and safety reverse test before we leave.
How a visit works
A Cable Repair Visit, Start to Finish
Your call is where it starts. Tell us what you see, such as a loose cable, a door hanging lower on one side, or a door that stopped partway. We schedule a visit, same-day when the schedule allows. The technician secures the door, releases the spring tension safely, and inspects the cables, drums, pulleys and bottom brackets. You hear what failed and get the price before work starts. We install the new cables, set even tension on both sides, and balance the door. We finish by testing the opener and the safety sensors while you watch.
Garage Door Cable FAQ
How do I know a garage door cable is broken?
Common signs are a door that hangs crooked, one side lower than the other, loose cable hanging beside the door, or a door that will not lift even though the opener runs. You may also have heard a loud bang when it let go.
Is it safe to open the door with a broken cable?
No. With one cable gone the weight shifts to the other side, and the door can jam, come off its track, or drop. Leave the door where it is and do not run the opener.
Should both cables be replaced at the same time?
We recommend it. The two cables are the same age and carry the same load, so when one fails the other is usually close behind. Replacing both keeps the door level.
Did a broken spring cause my cable to come off?
Often, yes. When a spring breaks the cables lose tension and can unwind from the drums. That is why we check the springs on every cable call, and the cables on every spring call.
Can I replace a garage door cable myself?
We do not recommend it. The cables attach to brackets and drums that are under spring tension, and releasing that tension without the right tools can cause a serious injury.


